belt question

Man I need alittle help, I think I know what to do but want to run it buy you guys. When Im in the deeper mud and getting in and out of the gas my belt chatters. Im going to try heavier weights, or get a v-force john clutch,lol. Does this sound right?

What set up u running now?

almond and red springs with stock weights

That's what I run and I can hear my belt to butmine is wore out, have you check your deflection? Sounds like its loose. You can buy shims fairly cheap to get it set

It was tight when I put it together, I think it might be all that power thats killing it,lol Or my thumb in the gas to far at times. I may call EPI and talk with them to see.

Alot of it is cause the belt exhaust comes right out in front of you, you'll hear all the noises and whatnot, will's is pretty loud to

Never thought of that, your right Im sure thats a bunch of it. I figured the weights would help the bite plus lower the stall alittle

I believe the CVT on the brute is the same as the Cat's, anyway, i had #52 lb wet springs and 20 gram rollers in which gave me a 3000 stall, so if u lower the grams on your weights it will stay in gear longer and if u increase the lb of the wet springs .it will increase the time its takes to engage the clutch..If that makes since lol

All that's in brutes clutches are 2 springs and weights, alot of people run the 56g weights which will help fine tune it, and do like Brandon said, I'm sure its just normal noise, will's is so loud it sounds like the motor is knocking but he is just running red secondary

I use to always think something was wrong with mine cuse it was so loud

like jeremy said mine is so loud that it sounds like the motor is knocking but you just get used to it. I can feel mine start to slip a little.

I shimmed my belt I run marroon prim and red sec but I also have an almond in tool box for pri ur deflection according to kawai is 22mm to 26mm which is .86 incus to 1.06 inches I run .75 inchs on 13 pound deflection no problem I have tool and a few shims if u need help not hard maybe 30 mins or so u can also lightly sand both sides of primary and secondary Pulleys with sand paper lighty to removed glazed areas that causes chatter my 2 cents